Automotive Accessories

Builder Turns Jeep Differential Upside Down for Budget Rear Portal Axle

Astrid BerglundNovember 17, 20265 min read1 views

At a glance

  • Zeph Gage's XJ Jeep uses a flipped Ford 9-inch differential, Humvee-derived hubs and custom fabrication to gain clearance at roughly one-fifth the cost of a typical portal-axle set.
  • Zeph Gage has built a rear-only portal axle for an XJ Jeep by flipping the differential and combining a Ford 9-inch housing with Humvee geared hubs. The custom setup adds about six inches of clearance at a fraction of the typical cost while avoiding front-end packaging constraints.
A conceptual illustration of a generic off-road SUV on a workshop lift, with an inverted rear differential and geared portal hubs visible at the wheels.

Zeph Gage has developed a low-cost portal-axle setup for an XJ Jeep by installing a single portal axle at the rear and flipping the differential upside down. The build combines a Ford 9-inch axle housing, geared hubs sourced from a Humvee and portal adapters from Jesse Haines Fabrication, with custom fabrication filling the gaps.

A cheaper route to portal clearance

Portal axles place a set of gears behind each driven wheel, allowing the axle shafts and other hardware to sit higher than a conventional drivetrain. That arrangement creates ground clearance and lets a vehicle run tall tires without hanging differentials and suspension parts low. A typical set from companies such as 74Weld costs about $20,000; Gage's rear unit comes in at about one-fifth of that.

Why the differential is upside down

Two-gear portal hubs, like the Humvee units used here, reverse the rotation of the input shaft. To make the Ford 9-inch work with them, Gage flipped the differential so the driveline spins in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, in effect turning low-pinion parts into a budget high-pinion arrangement.

The conversion is said to add about six inches of clearance. It also preserves full shock travel, a difficult goal with portal axles, and reduces stress on the differential itself. The arrangement is expected to be effectively bulletproof as a result.

Rear-only packaging trade-offs

Installing a portal axle only at the rear is a common trick in the remote-control rock-crawler scene. Keeping the solid front axle avoids the packaging constraints that arise when adding portal axles to a vehicle that never had them from the factory. It also allows Gage to retain shock travel and keep the ride height from becoming excessively tall.

With the rear end lifted, the Jeep can drive over a five-gallon bucket and still have several inches of spare clearance. That means the rear axle is less likely to hang up on obstacles that the front end can steer around.

Custom parts, not a bolt-on kit

The setup is not an off-the-shelf solution. Gage made custom brackets and custom-tapped plates, and paired a two-piece brake rotor with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric emergency-brake solenoid and helps with clearance.

The finished XJ illustrates how a rear-only portal conversion can add useful clearance without the cost and packaging work of a full four-wheel portal-axle swap. It required considerable custom thinking, but the effort was judged worthwhile.

Reported by Astrid Berglund, Vehicle Cargo and Roof System Analyst.